Control Module

The Control Module remotely switches pumps without controls and can be used in both positive and negative plumbing systems. The module incorporates run dry protection.

Complete with built in non-return valve, the units logic control senses either a pressure drop, or minimum flow of 1 lpm to automatically start the pump.

Should the supply become restricted or run-out then the control module will sense this and stop the pump to avoid damage.

Each mode of operation is indicated on the control panel.

 

General
Product code 41011
Guarantee 1 year
Features
Run on timer 3 sec
Dry run protection  
Performance
Maximum Liquid temperature ** 65 °C
Minimum liquid temperature 4 °C
Maximum flow 120 l/min
Cut in pressure 1.5 bar
Maximum working pressure* 1000 kPa (10 bar)
Maximum ambient air temperature 50 °C
Flow switch sensitivity (approx) 1 l/min
Connections
Connections G 1 male
Electrical
Power supply/phase/frequency 230 V a.c./ 1 / 50 Hz
220 V a.c./ 1 / 60 Hz
Current (full load) 8 Amps
Physical
Enclosure protection IP65
Height (from inlet to outlet) 165 mm
Weight (including fittings) 1.15 Kg


* The maximum pressure that can be applied to the pump under any installation conditions.

** A stored water temperature of 60 °C is considered sufficient to meet all normal requirements and will minimise deposition of scale in hard water areas.


Pump Variants
Part no Description
41011 Control Module 1.5 bar