Techflo qt Universal 2.3 bar Single - Shower & whole house pumps

Previous Products

The Techflo qt Universal 2.3 bar Single pump has been phased out and superseded by the equivalent Monsoon pump (for a whole house) or Showermate pump (for a single shower/bathroom).

For whole house applications, see Monsoon U3.0 bar Single

For single shower/bathroom applications, see Showermate U2.6 bar Single



Techflo qt Universal Single pumps can be used in pairs to pump hot and cold water supplies independently, or as a single pump to boost a water supply to an individual shower, complete bathroom or whole house. Suitable for both positive and negative head applications.

Universal pumps do not require a gravity flow of water to start.


  • Boost the water pressure in either the hot or cold supply

Technical Specification

Product code 49082
Guarantee 3 years
WRAS approval Approved materials
Pump type Centrifugal
Mechanical seal Nitrile / Carbon / Silicon Carbide
Anti vibration feet  
Inlet strainer(s)  
Flexible hoses 2
Run on timer 3 sec
Dry run protection  
Maximum head (closed valve) 2.3 bar
Performance @ 9 l/min 1.7 bar
Performance @ 18 l/min 1.2 bar
Maximum flow 32 l/min
Maximum static inlet pressure 6 metres
Maximum static outlet pressure 6 metres
Maximum working pressure* 460 kPa (4.6 bar)
Maximum ambient air temperature 40 °C
Min / Max water temperature** Min 4 °C / Max 65 °C
Flow switch sensitivity (approx) 1.0 l/min
Pressure vessel air pre-charge 0.9 bar (13 psi)
Pump connections 22 mm male
Flexible hoses
Connections 22 mm female x 22 mm push-in
200 mm long
isolating valves on inlet hose
Type Induction, auto-reset thermal trip
Duty rating Intermittent, 30 mins on, 30 mins off @ 20 l/min
Power supply/phase/frequency 230 V a.c./ 1 / 50 Hz
Current (full load) 1.2 Amps
Power consumption 290 Watts
Fuse rating 5 Amps
Power cable (pre-wired) 1.5 metres
Enclosure protection IPX2
Length 322 mm
Width 167 mm
Height (excluding hoses) 367 mm
Weight (including fittings) 6.4 Kg

* The maximum pressure that can be applied to the pump under any installation conditions.

** A stored water temperature of 60 °C is considered sufficient to meet all normal requirements and will minimise deposition of scale in hard water areas.