Showermate Standard 2.6 bar Single - Bathroom or shower pump

Showermate Pumps

Showermate Standard 2.6 bar Single pumps are designed to improve water supplies to single taps or to pump blended water from a shower mixer.  Suitable for positive head applications only.

Suitable for domestic use only, Showermate Standard pumps are suitable for installation into open vented hot and cold water systems.

Showermate Standard pumps require a flow of just 0.8 l/min through the outlet to start.


  • Boost the water pressure in either the hot or cold supply
  • Suitable for single or multiple (up to 4) outlets within a bathroom subject to correct specification and pump sizing

Technical Specification

Product code 46429
Guarantee 3 years
WRAS approval 1709101
Pump type Peripheral
Mechanical seal EPDM / PTFE / Al. Oxide
Anti vibration feet  
Flexible hoses 2
Dry run protection  
Pump body Plastic
Impeller Plastic
Maximum head (closed valve) 2.6 bar
Performance @ 9 l/min 1.3 bar
Maximum flow 18 l/min
Maximum static inlet pressure 13 metres
Maximum working pressure* 380 kPa (3.8 bar)
Maximum ambient air temperature 40 °C
Min / Max water temperature** Min 4 °C / Max 65 °C
Flow switch sensitivity (approx) 0.8 l/min
Pump connections G ¾ male
Flexible hoses
Connections G ¾ female x 15 mm push-in
200 mm long
Isolating valves on inlet hose
Type Induction, auto-reset thermal trip
Duty rating Continuous (S1) @ 9 l/min and above
Power supply/phase/frequency 230 V a.c./ 1 / 50 Hz
Current (full load) 1.1 Amps
Power consumption 245 Watts
Fuse rating 5 Amps
Power cable (pre-wired) 1.5 metres
Enclosure protection IP22
Length 223 mm
Width 132 mm
Height (excluding hoses) 179 mm
Weight (including fittings) 3.9 Kg

* The maximum pressure that can be applied to the pump under any installation conditions.

** A stored water temperature of 60 °C is considered sufficient to meet all normal requirements and will minimise deposition of scale in hard water areas.