CH 9-14 FL (50 Hz) - Centrifugal single stage automatic flow switch pump

CH

The CH Automatic Flow Switch range of centrifugal pumps are ideal for the pressurisation of water to outlets in a positive head application, where a gravity flow of approx. 1 l/min already exists.

Application

  • The range is suitable for commercial or domestic use, pumping hot or cold water

Technical Specification

General
Product code 46387
Guarantee 2 years
WRAS approval Approved materials
Features
Pump type Centrifugal
Mechanical seal EPDM / PTFE / Al. Oxide
Anti vibration feet  
Inlet strainer(s)  
Flexible hoses 2
Dry run protection  
Materials
Pump body Brass
Impeller Plastic
Performance
Maximum head (closed valve) 1.4 bar
Performance @ 45 l/min 1.2 bar
Performance @ 90 l/min 0.7 bar
Maximum flow 120 l/min
Minimum static inlet pressure 1 metre
Maximum static inlet pressure 14 metres
Maximum working pressure* 600 kPa (6 bar)
Maximum ambient air temperature 40 °C
Min / Max water temperature** Min 4 °C / Max 65 °C
Flow switch sensitivity 1.0 l/min
Connections
Pump connections G 1 male
Flexible hoses
Connections G 1 male x G 1 female x 300 mm long
Motor
Type Induction type, thermally protected
Duty rating Continuous (S1)
Electrical
Power supply/phase/frequency 230 V a.c./ 1 / 50 Hz
Current (full load) 2.0 Amps
Power consumption 445 Watts
Fuse rating 5 Amps
Power cable (pre-wired) 1.5 metres
Physical
Enclosure protection IPX4
Length 273 mm
Width 133 mm
Height (excluding hoses) 264 mm
Weight (including fittings) 7.7 Kg

 

* The maximum pressure that can be applied to the pump under any installation conditions.

** A stored water temperature of 60 °C is considered sufficient to meet all normal requirements and will minimise deposition of scale in hard water areas.