Monsoon N3.0 bar - won't start after power cut

chimpfeet 1 Posts 1 Karma
chimpfeet posted this 12 December 2017

As the title suggests, the pump won't start after a power cut.  The pump was in use when the power cut occured and now won't switch on (the power has been restored in case you're thinking I'm sitting in the dark wondering why the pump won't work...).  The pump was running without fault before hand, always cutting in immediatey upon opening the shower valve.  I've checked the electrical supply to the pump which is fine.  Any suggestions?

Post Edited 12 December 2017

PumpAssist 256 Posts 187 Karma
Admin
PumpAssist posted this 14 December 2017

It's quite likely the printed circuit board has blown due to the power cut.

It may be worth contacting your local service engineer and see if they can either repair the pump or sell you a pcb.

http://www.stuart-turner.co.uk/pumpassist/contact-an-approved-service-engineer/

We only sell the pcb as part of a complete service kit.

http://www.stuart-turner.co.uk/products/service-kits/monsoon-negative-(pre-2008)/